FAQ

My new build has a radon pipe. Why did it still test high?

Direct answer

Because a passive pipe has no fan. It relies on natural buoyancy, which the EPA rates well below active systems, and it only helps at all when the rough-in was run correctly. High tests in roughed-in Timnath and Windsor homes are routine.

More detail

The EPA's reduction figures put the gap plainly: passive stacks achieve a fraction of the reduction of an active system, because warm-pipe buoyancy is a whisper next to a fan's continuous pull. Meanwhile the tight envelope of a new home concentrates whatever still enters. There is also a quality lottery in rough-ins, since a rough-in is rarely tested once the house is finished: some stubs sit in proper gravel beds and run clean to the attic, others end capped under insulation, terminate beside an attic vent, or were never connected to a permeable layer at all. The fix is usually the cheap one, activation at $800 to $1,300, after an attic check confirms the stub is usable. Test first, in every case: the pipe's presence is not information about your air. The Timnath and Windsor new-build post covers the pattern.

Authoritative sources

Ready to get started?

About half of Fort Collins homes test at or above the EPA action level, and Larimer County averages six times the national figure. Mon-Sat 8am-6pm.

Call (970) 426-0858Text us

Prefer to text? Open your texting app